skip to main content
 

Hand auger equipment

Hand auger equipment is extremely suitable for soil research. As almost any type of soil sets its own demands where it concerns the model of the auger to be applied. In the course of the years many models have been developed. Years of experience and many contacts with soil researchers at home and abroad made it possible to achieve the optimum design for the four most popular types of hand augers:

Edelman augers, Riverside augers, Stony soil augers and Spiral augers. The augers have been made of a high grade non-toxic steel and a carefully selected hardening treatment contributes to achieve a wear resistant and solid design.

 

Edelman auger

This type of soil auger is by far the most used auger. The typical geodynamical design allows for a minimum of friction during penetration into and the extraction from the soil, which means less physical effort. There are 4 types: the clay-, sand-, coarse sand- as well as a combination type.

Item-No.: 42101 – Edelmann auger, clay type
Item-No.: 42102 – Edelmann auger, sand type
Item-No.: 42103 – Edelmann auger, coarse sand type
Item-No.: 42104 – Edelmann auger, combinations type

Riverside auger

This design is very suitable for augerings in hard, stiff soils, mixed with fine gravel both above and below the ground water level. The very sharp extremities of the auger bits point at an angle downwards which makes the auger go through the soil easily.

Item-No.: 42105

Stony soil auger

For soils with a large gravel content. The auger body for stony soils consists of a heavy steel strip, vaulted all along, which is bent double by forging. The pointed cutting bits of the strip are bent outward, thus creating a hole somewhat wider than the average body diameter.

Item-No.: 42106

Spiral auger

The spiral auger operates similar to a corkscrew and does not cut off the soil. The auger is usually applied when hard layers need to be penetrated, e.g. boreore, brick layers, chalk and lime profiles.

Item-No.: 42107